Regulations on the length of the electric karting track, the width of the straight section and the width of the curve:

1. The length of the runway, the width of the straight section and the width of the curve must meet the requirements.

2. The specified unit for the length of the runway, the width of the straight section and the width of the curve is meters.

Regulations on the length of straight sections:

1. The start line and finish line of the runway are set in the middle of the straight section. The length of the straight section of the runway shall comply with the regulations.

2. The specified unit for the length of a straight line section is meters.

Required materials for electric kart track pavement: The track pavement material of the outdoor kart yard should be the same modified asphalt, and the indoor kart can also be built with concrete or other hard materials.

The electric kart track pavement must meet the following quality requirements:

1. Compaction degree: the surface layer compaction degree is not less than 94% (measured by nuclear instrument)

2. Flatness: The flatness (gap) of asphalt gravel pavement surface is not more than 5mm; the flatness (gap) of asphalt penetration pavement surface layer is not more than 10mm; the flatness (gap) of asphalt pavement surface of cement concrete pavement is not more than 10mm. greater than 5mm.

3. Pavement skid resistance: the friction coefficient of the newly paved road surface is not less than 0.65, and the friction coefficient after one year of use is not less than 0.43 (measured by pendulum instrument).